5 / 6
Результаты исследовательских испытаний нового типа привода…
5
The results of research tests of a new type actuator based on
the effect of “Ultimate pneumatic hammer” in the radial
gas-static bearing
© Yu.V. Peshti, I.S. Tkachev
Bauman Moscow State Technical University, Moscow, 105005, Russia
The article considers a possibility of creating a drive based on the effect of “Ultimate
pneumatic hammer” in the radial gas-static bearing. It summarizes the conditions of oc-
currence of the effect of “limiting pneumatic hammer”. We
draw up recommendations
on the application of the drive in the air conditioning systems of modern aviation air-
craft, refrigeration. The prospects of the use of the drive as the rotating mechanism of
intrinsically safe shut-off valve are shown
. The
first results of theoretical studies of gas-
static bearings operating in the “limit pneumatic hammer” mode were obtained in a
three-dimensional mapping
. For the first time we present a stand for investigation of
driving performance, as well as the first results on the basis of which we defined
features
of occurrence of the “limiting pneumatic hammer” mode. Also we
found equations and
the structure of the phase diagram, corresponding the regimes “pneumatic hammer” and
“limiting pneumatic hammer”. Basic conditions for the appearance of the “limiting
pneumatic hammer” mode were established.
Also for the first time we clarified depend-
ence, which leads to the effect of “limiting pneumatic hammer”. The basic design and
operational requirements of the developed drive were determined. Analysis of the ob-
tained results allowed to put forward further steps of development and the shape of a new
drive.
Ключевые слова:
limiting pneumatic hammer, gas-static bearing, drive, air condition-
ing systems, aviation.
REFERENCES
[1]
Peshti Yu.V.
Gazovaya smazka
[Gas lubrication]
.
Moscow, BMSTU Publ., 1993,
381 p.
[2]
Trippet R.J., Oh K.P., Rohde S.M. Theoretical and Experimental Load-
deffection.
Studies of a Multileaf Journal Bearing. Tipies in Fluid Film Bearing
Design and Optimization: Presented of the Design Engineering Conference,
Chicago
. Illinois, 1978, April, рр. 130–156.
[3]
Design Gas bearings
. N.Y., Mechanical Technology Incorporated, 1969, 673 p.
[4]
Kunina V.V., Peshti Yu.V.
Vestnik MGTU im. N.E. Baumana, Ser. Mashi-
nostroenie — Herald of the Bauman Moscow State Technical University. Series
Mechanical Engineering
, 1998, pp. 151–159.
[5]
Certificate of authorship
no. 824714.
Sposob sozdaniya vrashchatel'nogo
dvizheniya vala
[A method for creating a rotational movement of a shaft].
[6]
Vygodsky
M.Ya.
Spravochnik po vysshey matematike
[Handbook on higher
mathematics]. Moscow, AST: Astrel, 2006, 246 p.
[7]
Idelchik I.E.
Spravochnik po gidravlicheskim soprotivleniyam
[Handbook on
hydraulic resistance]. Moscow, Mashinostroenie, 1992, 672 p.