Проектирование оптимальных циклов внутришлифовальной обработки в многомерном пространстве управляющих параметров

7 / 7

Проектирование оптимальных циклов внутришлифовальной обработки…
7
Designing optimal processing cycles of intragrinding
in a multidimensional space of controlling parameters
© A.V. Akintseva, P.P. Pereverzev
South Ural State University (national research university),
Branch in Kyshtym town, 456870, Russia
The article considers basic principles for designing optimal cycles for internal grinding
in a multidimensional space of controlling parameters: axis feed rate, radial feed, etc.
For the first time in order to optimize machining process we used such mathematical op-
timization method as a method of dynamic programming. Its application allows to take
into account the full range of technological limitations (on the allowable error of size, on
the allowable depth of burn mark and etc.), as well as to replace the exhaustive search of
solutions by the targeted one. This reduces the costs and time it takes at manufacture for
selection of the optimal characteristics of processing conditions.
Keywords: internal grinding, optimization of machining process, cycles, dynamic pro-
gramming.
REFERENCES
[1] D'yakonov A.A., Shipulin L.V. Selecting the cutting conditions for plain
grinding by the periphery of wheel. Russian Engineering Research, Allerton
Press, Inc, 2014, vol. 34, no. 12, pp. 804–816.
[2] Novoselov Yu.K. Dinamika formoobrazovaniya poverkhnostey pri abrazivnoy
obrabotke [The dynamics of shaping surfaces during abrasive processing].
Sevastopol, Sevastopol State University, 2012, 286 p.
[3] Nathan R.D., Vijayaraghavan L., Krishnamurthy R. Intelligent estimation of
burning limits to aid in cylindrical grinding cycle planning. Heavy Vehicle
Systems, 2001, vol. 8, iss. 1, pp. 48–59.
[4] Pereverzev P.P., Popova A.V., Pimenov . STIN — Russian Engineering
Research, 2014, no. 9, pp. 23–27.
[5] Bellman R. (1957) Dynamic programming. [in Russian: Bellman R.
Dinamicheskoe programmirovanie. Moscow, Izdatelstvo inostrannoi literatury,
1960, 400 p.].
[6] Pereverzev P.P. Vestnik Yuzhno-Ural'skogo gosudarstvennogo universiteta.
Ser. Mashinostroyeniye — Bulletin of the South Ural State University, Series
“Mechanical engineering industry” 2012, № 12 (271), с. 152–157.
[7] Popova A.V. STIN — Russian Engineering Research, 2014, no. 6, pp. 17–22 с.
[8] Pereverzev P.P., Popova A.V. Sovremennyye problemy teorii mashin —
Modern problems of the theory of machines, 2015, no. 3, pp. 22–25.
Akintseva A.V., assistant lecturer of the Department “Technologies of Material Pro-
cessing” at the Branch of the South Ural State University in Kyshtym town. e-mail:
Pereverzev P.P., Dr. Sci. (Eng.), professor of the Department of Mechanical Engineering
Technology at the South Ural State University. e-mail: