6 / 6
А.В. Афонин, Е.А. Носова
6
Experimental study of temperature field in the cutting
hearth when milling alloy VT-6
© A.V. Afonin, E.A. Nosova
Samara State Aerospace University (National Research University),
Samara, 443086, Russia
Up to now processing of materials by cutting is the basic method for manufacturing en-
gineering products. Cutting efficiency of the cutting process increases as a result of re-
search in various areas of material processing. The article describes an experiment of
studying temperature field in the cutting hearth when milling alloy VT-6.
Based on these
data the dependence of maximum heating temperature of the alloy in the hearth of cut for
each pass of the milling cutter has been plotted.
It was established that the maximum
heating temperature in the hearth increases with increase of the number of passes of the
cutter over the surface of the workpiece.
Keywords:
processing of materials, cutting, temperature field, hearth of cutting
.
REFERENCES
[1]
Tkachenko P.V., Loktik A.V.
Issledovanie chistovogo tortsovogo frezerovaniya
titanovogo splava
[Research of the finish face milling of titanium alloy].
[Electronic resource], 2006, no. 5. Available at:
http://www.kdu.edu.ua/statti/2006-5-1(40)/69.pdf (accessed September 18, 2015).
[2]
Kolachev B.A., Elagin V.I., Livanov V.A.
Metallovedenie i termicheskaya
obrabotka tsvetnykh metallov i splavov
[Metal Science and heat treatment of
nonferrous metals and alloys]. Moscow, MISIS, 1999, 416 p.
[3]
Ilyin A.A., Kolachev B.A., Polkin I.S.
Titanovye splavy. Spravochnik
[Titanium alloys. Handbook]. Moscow, VILS – MATI, 2009, 520 p.
[4]
Krivoukhov V.A., Chubarov A.D.
Obrabotka rezaniem titanovykh splavov
[Machining of titanium alloys]. Moscow, Машиностроение, 1970, 180 p.
Afonin A.V.,
a student of Samara State Aerospace University.
e-mail:
afonin.alecksander@yandex.ruNosova E.A.,
associate professor of the Material Sciences Department at Samara State
Aerospace University.